The easy-to-clean solution for used polishing pads!
Removes product residues from foam, wool and microfiber pads
Rinses completely clean to restore performance
Leaves pads looking, feeling and performing like new
Go ahead, pamper your pads!
BLACKFIRE Citrus Pad Cleaner restores your foam, wool, and microfiber polishing pads by fully removing all product residues. When polishing pads are cleaned thoroughly after every use, they maintain their texture and performance far longer than neglected pads. Not only does maintaining your pads save money, you will get better results as well. Keep your pads polishing flawlessly with BLACKFIRE Citrus Pad Cleaner.
Formulated specifically for the cleaning requirements of polishing pads, BLACKFIRE Citrus Pad Cleaner cleans polish, wax and sealant residue from deep within the pads pores or fibers. If these residues are not fully removed, your pad's performance will suffer the next time you use it. For example, a pad clogged with wax residue can overheat when used with a machine polish. It's not the polishes' fault – the pad wasn't clean.
Allowed to soak into foam pads, BLACKFIRE Citrus Pad Cleaner penetrates the foam pores and releases any oily residues. On wool or microfiber pads, BLACKFIRE Citrus Pad Cleaner releases the residue while restoring the original texture. Your pads will perform like new, time after time.
BLACKFIRE Citrus Pad Cleaner works great on microfiber towels as well. The powerful, citrus-based cleaning power will remove any wax, grease, or dirt from the microfiber and restore its nature texture. BLACKFIRE Citrus Pad Cleaner makes an excellent “pre-soak” for grimy and filthy towels.Directions:
Mix 1 scoop of BLACKFIRE Citrus Pad Cleaner with 3-4 gallons of water. Place soiled polishing pads into bucket after use and allow to soak for 15 minutes. Massage cleaner through out the pad and rinse clean. Allow pads to dry face down.
Add one scoop of cleaner to 3-4 gallons of water and mix around until the solution feels "slick".
Squeeze out as much solution and polish residue as possible.
Then set the pad face down to allow any water to drain out and evaporate.