Proper Klasse Application
Proper Application of Klasse All-In-One
Proper Klasse application requires a proper applicator. Ask any Klasse-phile and they will tell you that using a Microfiber Applicator makes all the difference here!
Klasse All-In-One is not very particular about application, but Klasse Sealant Glaze must be applied as a very thin coating or it will be difficult to remove More on that later.
For Klasse AIO application, use a Microfiber Applicator
Work on a single panel at a time. I recommend applying a 1-inch size dab of Klasse All-In-One to your applicator and work it in well. Polish until the film is nearly gone.
Allow Klasse All-In-One to haze for just a moment and buff off with a Gold Plush Jr Microfiber Towel. The Gold Plush Jr. has just the right texture to make Klasse All-In-One removal a cinch.
After polishing with Klasse All-In-One, give your car's paint a quick wipe down with Wolfgang Instant Detail Spritz This will remove any remaining polish residue and makes Klasse Sealant Glaze application much easier.
Proper Application of Klasse Sealant Glaze
Klasse Sealant Glaze is very finicky about proper application due to its durable acrylic formula. If you applied heavliy like a paste wax, it will be very difficult to wipe off.
So, I repeat, Klasse Sealant Glaze must be applied as a very thin coating or it will be difficult to remove.
The proper film application thickness for Klasse Sealant Glaze is "whisper thin". There should be very little Klasse Sealant Glaze film to remove when it is properly applied.
For Klasse Sealant Glaze I only recommend using a Microfiber Applicator. This applicator evenly distributes just the right amount of Klasse Sealant Glaze.
Before starting, moisten the Microfiber Applicator with a small amount of Wolfgang Instant Detail SpritzOne or two sprays is plenty.
Apply Klasse Sealant Glaze to your entire car. Do not wipe off until it is dry. I recommend applying no more than a 1/2-inch size dab of Klasse Sealant Glaze to your applicator at a time. Work it in well. Remember, rub the Klasse Sealant Glaze in until only a whisper of film remains.
Allow the Klasse Sealant Glaze film to dry for about 30 minutes. In most cases, once you are finished applying Sealant Glaze, you can begin buffing off where you started your application. Allowing the Sealant Glaze to dry longer will not make it easier or more difficult to buff off.
For best results, buff off Klasse Sealant Glaze with a Gold Plush Jr Microfiber Towel. Klasse Sealant Glaze responds well to the short nap fabric side for removal. Flip to the super soft, plush side for final buffing.
If you do apply your Klasse Sealant Glaze to heavily, use a light spray of Wolfgang Instant Detail Spritz to assist with removal.