Nanoskin AutoScrub Fine Grade Wash Mitt
Fast paint decontamination wrapped around your hand!
Coated microfiber mitt for easy and fast paint cleaning as you wash your vehicle
Lasts up to 4 times longer than clay bars
Washable and reusable, you can even drop it on the ground
The Nanoskin AutoScrub Fine Grade Wash Mitt makes paint decontamination easy and effortless. This easy to use mitt fits snugly over your hand and removes bonded contaminants as you wash your car. One side of the soft microfiber construction has been infused with the latest advanced polymer rubber technology. This mitt replicates the paint cleaning action of a fine grade clay bar to remove bonded surface contamination from your paint safely and without scratching. Not only does the Nanoskin AutoScrub Fine Grade Wash Mitt work faster then a traditional clay bar, it is washable and reusable as well.
Shortly after leaving the factory, your vehicle is bombarded with airborne pollutants and contaminants that ruin the smooth feel of paint, limit its shine, and prevent waxes and paint sealants from bonding properly. In the old days, body shops and detailers would use aggressive compounds and a wool pad to clean the paint. Next, natural and synthetic clay bars where developed to clean contamination and over-spray Detailing clay is still the tool of choice, and for good reason. You can clean your paint without damaging it, unlike the compounds of yesterday.
The Nanoskin AutoScrub Fine Grade Wash Mitt is the next generation in paint cleaning. It works much like detailing clay, but with several advantages. The microfiber mitt design fits over your hand to reduce fatigue while using. The rubber polymer side acts in the same manner as detailing clay, safely removing contamination, pollutants, and over-spray The short nap microfiber side is perfect for wiping away excess lubricant. Nanoskin AutoScrub Fine Grade Wash Mitt lasts up to four times longer than traditional detailing clay and rinses clean in water. Drop it on the ground? No problem, rinse off and keep working!
Directions: Use only on clean and cool surfaces. Mix one ounce of Nanoskin Bubble Bath Wash & Shine Shampoo per gallon of water. Rinse surface with water to flush away loose dirt. Wash and rinse in sections using Autoscrub Wash Mitt using light pressure. Begin with the roof, and work the suds down to the hood, trunk and sides. Rinse with clean water and dry vehicle using a Waffle Weave Guzzler Drying Towel.
Note: This is the Fine Grade AutoScrub Mitt, designed to remove light to moderate contamination quickly. It is safe for fine and delicate paints. A Medium Grade AutoScrub Mitt is available and recommended when working on heavily contaminated finishes.
Overall Rating for Nanoskin AutoScrub Fine Grade Wash Mitt