Protect your headlights and fog lights from rocks and road debris!
Backed by a 7-year warranty.
The XPEL Headlight Protection Film Kit provides durable, long-lasting protection for your vehicle’s headlights and fog lights. Headlights and fog lights equipped with the film are less likely to get chipped and cracked from rocks and other road debris. What’s more is the XPEL Headlight Protection Film Kit is available for hundreds of popular makes and models. Find the kit for your vehicle and get protected!
Most vehicles made in the last 25 years feature headlights that are constructed of a composite material. Over time, the lenses will crack, fade and yellow. As you drive your vehicle, it is bombarded with road debris, rocks, road salt and even sand. All of this takes its toll on your vehicle, especially your composite headlight and fog light lenses. The XPEL Headlight Protection Film Kit protects your headlights and fog lights from the elements so they look new for years.
The XPEL Headlight Protection Film Kit can actually help to restore the appearance of lights that are showing signs of wear from pitting. The adhesive film fills in microscopic defects, creating a smooth, shiny finish while protecting from further damage. The XPEL Headlight Protection Film Kit is non-yellowing and will retain its optical clarity for years. XPEL is so confident, they even back it with a 7-year warranty.
Headlights and fog lights are expensive, costing upwards of $800-$1000 on some vehicles. Real world testing has proven that the XPEL Headlight Protection Film Kit can withstand a barrage of 1” diameter stones (about 1 oz.) at speeds up to 120 miles per hour with no damage to the lens they protect.
Do away with replacing costly lenses due to cracking and yellowing and protect them for years with the XPEL Headlight Protection Film Kit.Installation tips:
Please enter your vehicle's year, make, and model in the ordering form. Please enter the sub-model if applicable.
- Be sure to overlap strokes to avoid trapping air or solution under the material. Bubbles tend to form most often at curves and contours, so pay special attention in these areas.
- Don't be afraid to stretch the material. The plastic is very resilient and can be stretched extensively without harming the kit. This stretching is imperative for proper fit, as our kits are designed to be stretched to reduce the amount of excess material near the edges of contoured surfaces
- The material may be gently pulled back up in areas if necessary to reposition the kit, or if you find that you have trapped dirt, air or an excessive amount of solution under the material. Do not worry about small pockets of solution trapped under the material, as over time the solution will evaporate, making the spot unnoticeable. Air, however, must be removed.
- Any attempt to pull the material back up must be done within 10 minutes of application or excessive stretching will occur, so check the kit often for bubbles. If you accidentally stretch the material too far, you may end up with the kit overlapping the edges of the panel.